Doccol Corporation DOCCOL CORPORATION
Serving Stroke Research Since 2004
  Top » Catalog » MCAO Procedures My Account  |  Cart Contents  |  Checkout    
MCAO Procedures

Modifications of Surgical Procedures for Intraluminal MCAO Models

 

I would recommend you to watch the movie of "MCAO model in the Rat" published on Journal of Visualized Experiments by Uluç et al, and the movie of MCAO in miceby Engel et al. The article provides great details on MCAO surgical procedures. There are two vascular approaches for intraluminal access of MCA, the ECA approach and the CCA approach, which has to be determined before your formal experiments start. The ECA approach provides better reperfusion through CCA whilst the CCA approach can only provide reperfusion through Willis Circle. A recent study by Morris, et al systematically compared the Variables influencing ischemic injury in these approaches, providing useful information for selecting the optimal vascular approach.

Learning intraluminal MCAO Models from the following selected video articles.
Stroke model in rats. Stroke model in mice.
In order to further optimize your MCAO models, we suggest the following modifications for your regular surgical procedures:

 

  1. Define the animal size for your study. Do a pilot study to determine the optimal tip diameter, coating length, and optimal inserted length of the MCAO suture for your animals. This step is critical for the success of your stroke modeling.
  2. Before your MCAO procedures, weigh your animals, and match monofilament diameters in proprotion to animal body weights.
  3. Mark the predetermined optimal inserted length on the bare surface of monofilaments using the Sharpie Metallic Silver marker pen, which we provide for your convenience.
  4. Disinfect monofilaments with 70% ethanol. The reusable filaments are autoclavable under a proper temperature and for a limited duration.
  5. Tie a knot around the external carotid artery at a position 1-2 mm upbloodstream to the point where the monofilament is to be inserted. This knot should be easy to loosen, or be reopened, and also tight enough to stop bleeding.
  6. Once the monofilament has been advanced to the pre-marked desired length, it will be necessary to apply a micro vasselclip on the internal carotid artery so to immobilize the inserted monofilament. Dislodging of monofilaments occurs frequently after animals wake up and move around.
  7. Use laser-Doppler flowmetry for guiding filament placement and the identification of subarachnoid haemorrhages and premature reperfusion. (Morris 2016)
  8. For reperfusion, we suggest you do the following actions in sequence: loosen the knot that you tied in step 5, temporarily open the micro vessel clip, withdraw the monofilament, re-apply micro clip after the monofilament has passed over the position where the micro vessel clip applied, continue withdraw the monofilament until it has passed the opened knot, then re-tie the knot to stop bleeding. When these procedures have been finished, reperfusion will occur when you remove the micro vesselclip.
  9. Carefully clean the recovered monofilament if you intend to reuse it. The recovered monofilament may be reused if its coated surface is intact. The tip diameter and surface smoothness may hav been altered during the process of inducing an MCAO model and reperfusion. Applying a little siliconee oil (Sigma, choose the ones with the lowest viscosity) to the coated surface may increase smoothness.
Continue

Copyright © 2017 Doccol Corporation
30 Eisenhower Drive, Sharon, MA 02067-2427, USA
Toll-free Tel: (888) 481-0842; Fax: (888) 893-5285